Guide + connection service — not a deck builderNational methods authority · your town is asked on the request form

Method Deck
The Method Plates — how a deck is actually put together, stage by stage

Decide · Permits & codes

Permits & codes: the IRC is the floor; your town writes the rest

Honest framing first: this page states the widely adopted International Residential Code baseline and the usual shape of local practice. It is not legal advice and it does not know your town. The building department where the deck will stand is the only authority whose answer counts — and getting that answer in writing before you build is the cheapest step in the whole method.

When a permit is typically required

Most jurisdictions require a permit for a deck that is attached to the house, or over 30 inches above grade, or above a size threshold (200 sq ft is a common one) — and many require one for any deck at all. The common exemptions (small, low, freestanding platforms) are narrower than folklore suggests, and an exemption from a building permit never exempts you from zoning: setbacks from property lines, lot-coverage limits and easements apply to permitted and unpermitted structures alike. HOA approval, where an HOA exists, is a separate gate again.

What gets inspected

Typically: footing holes before pouring (depth and soil), framing before the surface hides it (ledger fastening, flashing, hangers, spans), and a final (guards, stairs, lateral connections). A deck built without a permit gets all three inspections' worth of doubt at resale — disclosure forms ask, buyers' inspectors look, and unpermitted work is priced as a liability even when it was built well.

The IRC baseline numbers used across this site

ItemIRC baselineWhere it appears
Guard height (residential)36 in. minimum where deck is >30 in. above gradeRailings & stairs
Guard openingsReject a 4-in. sphereRailings & stairs
Stair riser / treadMax 7¾ in. / min 10 in.Railings & stairs
Footing depthBelow local frost lineFootings
Ledger fastening½-in. bolts/lags per span table; flashing requiredFraming & flashing
Lateral loadRated tension devices tying deck to houseFraming & flashing

What local variation actually looks like

Snow-load regions deepen footings and shrink spans. Coastal zones add wind-uplift connectors and stainless hardware. Some states license deck builders specifically; many license them as home-improvement contractors with registration numbers you can verify; a few barely regulate the trade at all — which raises, rather than lowers, the value of the permit and inspection trail. When a builder discourages a permit, they are telling you which inspections they expect to fail; believe them.